This is where you discuss the conditions of your crabitat -- temperature, humidity, substrate, decorating, etc.
-
Topic author
Steph
- Posts: 1
- Joined: Thu Mar 14, 2019 1:27 am
- Location: Melbourne
Post
by Steph » Sat Apr 13, 2019 5:10 am
Hi,
I am wondering what is the better option for heating a crabitat, a heat lamp or a heating pad?
Thanks,
Steph

-
ha_haley
- Posts: 70
- Joined: Sat May 19, 2018 2:36 pm
Post
by ha_haley » Sat Apr 13, 2019 5:13 am
An under the tank heater is what is recommended. With hermit crabs, do not place the heater under the tank. Place it on the back of the tank above the substrate. You want to heat the air, not the sand.
Heat lamps aren’t recommended because they zap the humidity. Crabs have modified gills and need high humidity to be able to breathe.
Sent from my iPhone using Tapatalk
-
wodesorel
- Tech Support

- Posts: 9175
- Joined: Thu Oct 01, 2009 8:49 am
- Location: Leetonia, Ohio
-
Contact:
Post
by wodesorel » Sat Apr 13, 2019 12:17 pm
I've used both, and have switched all my tanks to pads. Much easier to use, and less expensive in the long run as there are no bulbs to break or blow!
-
HeinzMar
- Posts: 2
- Joined: Fri May 03, 2019 10:45 am
- Location: Hungary
-
Contact:
Post
by HeinzMar » Sun May 19, 2019 3:55 am
Ive never looked, but do they make heating pads with thermostats? If not, youd be cooking the tank because the heat would never turn off. Not to mention, a heat pad gets a lot warmer than the traditional aquarium heater meant for that size tank.
-
odelayheehoo
- Posts: 269
- Joined: Sat Feb 16, 2019 4:36 pm
Post
by odelayheehoo » Sun May 19, 2019 9:58 am
I just dislike heating lamps due to the fact that you can't set them down on glass lids or they will crack, and they have a higher chance of drying out the substrate and zapping humidity. It's much easier if you install a heating pad like an ultratherm with insulation if needed.
You can buy thermostats that you plug the heaters into to control the temperature, but often those are not needed.
-
JoeHermits
- Posts: 576
- Joined: Wed Apr 04, 2018 9:26 pm
Post
by JoeHermits » Sun May 19, 2019 10:32 am
odelayheehoo wrote:I just dislike heating lamps due to the fact that you can't set them down on glass lids or they will crack, and they have a higher chance of drying out the substrate and zapping humidity. It's much easier if you install a heating pad like an ultratherm with insulation if needed.
You can buy thermostats that you plug the heaters into to control the temperature, but often those are not needed.
My house gets into the eighties and nineties in the summer, so I have a thermostat so I don’t accidentally cook my crabs.
Sent from my iPhone using Tapatalk
-
wodesorel
- Tech Support

- Posts: 9175
- Joined: Thu Oct 01, 2009 8:49 am
- Location: Leetonia, Ohio
-
Contact:
Post
by wodesorel » Sun May 19, 2019 10:59 am
HeinzMar wrote: ↑Sun May 19, 2019 3:55 am
Ive never looked, but do they make heating pads with thermostats? If not, youd be cooking the tank because the heat would never turn off. Not to mention, a heat pad gets a lot warmer than the traditional aquarium heater meant for that size tank.
They do! There are several brands, and they are sold for reptiles to tightly control the basking temperature to prevent thermal burns from when a reptiles lays on top of where the pad is placed. UTHs do naturally have a max temp (around 120-140 degrees F and will cycle on and off, so the way we use them for hermits - on the back of the tank to warm the air - thermostats are not normally needed. The crabs won't be touching them and they don't usually get hot enough to cause trouble.
An aquarium heater used to heat water is a whole different kind of heater. And actually, it takes a LOT more power to keep the same volume of water heated than it does air. In my extremely cold bedroom in winter, I can warm a 20 gallon hermit tank to 80 with around 20W of power, but it takes around 200W to do the same with my same size fish tank. True that the pad gets hotter to the touch than the heater inside the tank, but that's only because the constant flow of water is keeping it cooler by moving the heat away as soon as it's produced. Add in a little moving air and the pad would also stay much cooler.
-
odelayheehoo
- Posts: 269
- Joined: Sat Feb 16, 2019 4:36 pm
Post
by odelayheehoo » Sun May 19, 2019 11:23 am
JoeHermits wrote: ↑Sun May 19, 2019 10:32 am
My house gets into the eighties and nineties in the summer, so I have a thermostat so I don’t accidentally cook my crabs.
Sent from my iPhone using Tapatalk
My heaters remain unplugged for the entire summer, and I watch the weather forecast for the night in case it gets chilly unexpectedly.
-
PinchersAndShells
- Administrator

- Posts: 1314
- Joined: Tue Aug 16, 2016 12:02 pm
- Location: Ohio
-
Contact:
Post
by PinchersAndShells » Tue May 21, 2019 10:04 pm
I had to break down and buy a thermostat for my heat mat because the tank was getting up to 90°F in winter! Whether or not you need one really depends on the temperature of your house and how well the mat works. I bought a thermostat meant for seed germinating on Amazon for my Ultratherm and it works wonderfully.