Page 1 of 1
MOLD !!
Posted: Wed May 06, 2009 12:14 am
by addicted2hermies
so I thought adding the needed humidity was going to be easy, now i have mold & mites
HELP! what can mold cause to the crabitat? can ithurt the crabs? I want to deep clean but I have a molter or 2 :/ what can I do to prevent mold/mites? & what is mold/mites most likely to be found on?
Posted: Sun May 10, 2009 4:01 pm
by Guest
As soon as the molting crab comes up thoroughly clean the tank. Mold is NOT good.
Posted: Sun May 10, 2009 8:20 pm
by Guest
Mold is bad. For now, you can spot clean and remove as much surface mold as you can, then take about a table spoon of vinegar and a cup of water and spray or pour a bit where the mold was. It should keep the spores under control, but not too much.
Molter
Posted: Sun May 10, 2009 8:37 pm
by tojo
I've had success in carefully displacing molters into the isolation tank. In fact they will be better off there. Carefully dig around the molter, pick him up sand and all, and gently place him in a pre-dug hole in isolation. Make sure the sand has a good moist consistency and carefully cover him over.
Deep cleans are important especially if mold and bugs are involved.
Good Luck!
~ Tojo
