HCA: Hermit Crab Association

I'm planning to build a 4ft by 1.6ft by 2.5ft tank (ik weird dimensions) with build in pools, each 3.3 gallons on the right side of the tank. I was just wondering is 10mm glass sufficient to build this tank assuming there are 3 2-inch braces on top of the tank? And also, is there any way to further ensure that the built in pools will not leak/break? Any advice is welcome:)

I just did something similar with acrylic. The glass on a normal tank is about an 1/8 inch (idk what that is in mm) but large tanks can get up to 1/2 inch. With the braces you’ll probably be good with 1/8-1/2 inch.
If you’re using glass you can use silicone to seal it. But with acrylic the silicone won’t stick and it WILL leak. In that case you use weld on 3.


Sent from my iPhone using Tapatalk

ah ok thank you very much:)